Topcoat Carpark System
Hard Wearing Anti-Slip Epoxy Resin Floor Screed.
Topcoat Carpark system is a hard wearing anti-slip resin floor screed suitable for use in wet areas. It is hygienic and easy to clean and comes in a large range of colours.
The system consists of five steps:
- Concrete sub floor properly prepared. Vacuum blasting or surface diamond
grinding is preferred
- Priming coat of Primer 2000 is applied.
- While primer is still wet the surface is blinded with Quartz aggregate
-For intermediate decks 0.4 – 0.8 mm Quartz aggregate is applied
-For roof decks and ramps 0.7 – 1.2 mm Quartz aggregate is applied
After curing excess Quartz aggregate is removed
- Epoxy screed Topcoat 2000 is applied using a squeegee followed by application of Quartz aggregate and then back rolled.
Carparks, Fire stations, Workshops, Processing areas, Corridors, Laboratory areas, Warehouses etc
Battleship Grey (dark Grey), Gunmetal Grey (light Grey). Leaf Green, Marine Blue, Sky Blue, Honey Yellow, Sand Yellow, Tomato Red, Tile Red.
Conforms to EN 13813:2002
Conforms to British Slip Resistance Standard No. BS7976-2:2002 under both wet and dry conditions.
Concrete or substrate should be a minimum of 25N/mm2, free from laitance, dust and other contamination. The substrate should be dry to 75% RH as per BS 8204 and free from rising damp and ground water pressure. If no damp proof membrane is present D-Proof DPM can be used.Technical Information:
- Solids content – 100%
- Product is solvent free
- Mix ratio – 4:1 by weight
- Pot Life – 25 mins @ 200C
- Cure Time – 8 hrs @ 200C
- Gunmetal Grey RAL 7040
- Tile Red RAL 3009
- Battleship Grey RAL 7031
Non Standard Colours
- Leaf Green RAL 6002
- Sky Blue RAL 5015
- Sand Yellow RAL 1002
- Tomato Red RAL 3013
Topcoat 2000 can be used as a roller coat and is included as part of the following systems – Topcoat Flake. Topcoat Antislip, Topcoat Quartz
CE Labelling EN 13813 :2002
|Essential Characteristics||Performance||Technical Specification
|Flexural Strength||>20N/mm2||EN 13813:2002|
|Wear Resistance||AR2||EN 13813:2002|
|Bond Strength ||>1.5N/mm2||EN 13813:2002|
|Compressive Strength ||>45 N/mm2||EN 13813:2002|
|Impact Resistance||IR4||EN 13813:2002|
|Shore D Hardness||76||DIN 53505|
Health and Safety:
Skin and eye contact should be avoided by use of suitable protective clothing such as gloves, goggles, apron etc.
Use in well ventilated area. In the event of eye contact flush with water for 15 minutes and seek medical attention.